Notifications
Clear all
MackDan
Skupina: Registrovaný
Přidal se: 2022/12/12
Active Member
1
|
Instead of trying to open a .stl file I tried to repair a ra... In forum PrusaSlicer |
před 2 years | |
|
I can't even click on a file to try and load it. Once I clic... In forum PrusaSlicer |
před 2 years | |
|
PrusaSlicer locks up trying to load a .stl In forum PrusaSlicer |
před 2 years | |
|
I think I figured it out. Not PrusaSlicers fault, just IDEX ... In forum PrusaSlicer |
před 2 years | |
|
I'm not having problems with the Extruders. They [0], and [1... In forum PrusaSlicer |
před 2 years | |
|
Bed temp goes to zero at layer 2 In forum PrusaSlicer |
před 2 years |