Notifiche
Cancella tutti
luke.m8
Gruppo: Registrato
Registrato: 2017/10/09
Active Member
1
| Thanks! | 6 years fa | |
| So the only difference between USB and using GPIO is the nee... | 6 years fa | |
|
I'll +1 this.
I like Sli3er but
a) some of my model do sup... Nel forum Hardware, firmware and software help |
7 years fa | |
|
Just tried the 3.2.1 version that just installed.
This time ... Nel forum Others (Archive) |
7 years fa | |
|
Thanks yea that sounds like a plan. Nel forum Others (Archive) |
7 years fa | |
|
Help getting Cura 3.2.0 setup Nel forum Others (Archive) |
7 years fa | |
|
So I tried that.
I paused the print and it sent the head to... Nel forum Others (Archive) |
7 years fa | |
|
Pausing Print Nel forum Others (Archive) |
7 years fa | |
|
Thanks for the help.
It was that and also the X axis was sli... Nel forum Others (Archive) |
7 years fa | |
|
XYZ Calibration Keeps Failing on New Build Nel forum Others (Archive) |
7 years fa |