Avisos
Vaciar todo
luke.m8
Grupo: Registrado
Registrado: 2017/10/09
Active Member
1
| Thanks! | hace 6 years | |
| So the only difference between USB and using GPIO is the nee... | hace 6 years | |
|
I'll +1 this.
I like Sli3er but
a) some of my model do sup... En el foro Hardware, firmware and software help |
hace 7 years | |
|
Just tried the 3.2.1 version that just installed.
This time ... En el foro Others (Archive) |
hace 7 years | |
|
Thanks yea that sounds like a plan. En el foro Others (Archive) |
hace 7 years | |
|
Help getting Cura 3.2.0 setup En el foro Others (Archive) |
hace 7 years | |
|
So I tried that.
I paused the print and it sent the head to... En el foro Others (Archive) |
hace 7 years | |
|
Pausing Print En el foro Others (Archive) |
hace 7 years | |
|
Thanks for the help.
It was that and also the X axis was sli... En el foro Others (Archive) |
hace 7 years | |
|
XYZ Calibration Keeps Failing on New Build En el foro Others (Archive) |
hace 7 years |