Notifications
Clear all
luke.m8
Skupina: Registrovaný
Přidal se: 2017/10/09
Active Member
1
| Thanks! | před 6 years | |
| So the only difference between USB and using GPIO is the nee... | před 6 years | |
|
I'll +1 this.
I like Sli3er but
a) some of my model do sup... In forum Hardware, firmware and software help |
před 7 years | |
|
Just tried the 3.2.1 version that just installed.
This time ... In forum Others (Archive) |
před 7 years | |
|
Thanks yea that sounds like a plan. In forum Others (Archive) |
před 7 years | |
|
Help getting Cura 3.2.0 setup In forum Others (Archive) |
před 7 years | |
|
So I tried that.
I paused the print and it sent the head to... In forum Others (Archive) |
před 7 years | |
|
Pausing Print In forum Others (Archive) |
před 7 years | |
|
Thanks for the help.
It was that and also the X axis was sli... In forum Others (Archive) |
před 7 years | |
|
XYZ Calibration Keeps Failing on New Build In forum Others (Archive) |
před 7 years |