Notifications
Clear all
lschelvis
Skupina: Registrovaný
Přidal se: 2023/07/27
Active Member
1
| yeah, I looked for myself 🙂 I'd like to print the correct ... | před 8 months | |
| Printable components MMU3 for MK4 | před 8 months | |
|
Manual color changes -> ramming possible? In forum Hardware, firmware and software help |
před 12 months | |
|
Just finished a successful multi color print with the downgr... In forum Hardware, firmware and software help |
před 12 months | |
|
Just downgraded the printer 5.0.1 and the print starts (slic... In forum Hardware, firmware and software help |
před 12 months | |
|
Filament changes causes printer to crash In forum Hardware, firmware and software help |
před 12 months | |
|
Same here, firmware on 5.1.0 and PrusaSlicer on 2.7.0. No pr... In forum Hardware, firmware and software help |
před 12 months | |
| Thanks, I will take a look at this! | před 1 year | |
| After a few months printing very good, I wanted to print som... | před 1 year | |
| Thanks for the tip for the teststrip for eight settings. It ... | před 1 year | |
| Again, first layer | před 1 year |