Benachrichtigungen
Alles löschen
lschelvis
Gruppe: Registriert
Beigetreten: 2023/07/27
Active Member
1
| Upgrading from MK4S + MMU3 to CoreOne | Vor 3 months | |
| yeah, I looked for myself 🙂 I'd like to print the correct ... | Vor 2 years | |
| Printable components MMU3 for MK4 | Vor 2 years | |
|
Manual color changes -> ramming possible? Im Forum Hardware, firmware and software help |
Vor 2 years | |
|
Just finished a successful multi color print with the downgr... Im Forum Hardware, firmware and software help |
Vor 2 years | |
|
Just downgraded the printer 5.0.1 and the print starts (slic... Im Forum Hardware, firmware and software help |
Vor 2 years | |
|
Filament changes causes printer to crash Im Forum Hardware, firmware and software help |
Vor 2 years | |
|
Same here, firmware on 5.1.0 and PrusaSlicer on 2.7.0. No pr... Im Forum Hardware, firmware and software help |
Vor 2 years | |
| Thanks, I will take a look at this! | Vor 2 years | |
| After a few months printing very good, I wanted to print som... | Vor 2 years | |
| Thanks for the tip for the teststrip for eight settings. It ... | Vor 2 years | |
| Again, first layer | Vor 2 years |