Prusa3D Forum

Notifiche

Cancella tutti

Logical Waste

Gruppo: Registrato

Registrato: 2017/02/13

Active Member

	Filament Runout Sensor triggers too late. Nel forum Hardware, firmware and software help	7 years fa
	Slice it again and set the fan to come on at layer 3. I'm go... Nel forum Hardware, firmware and software help	7 years fa
	The printer works fine at tempts 225 or below. The very sec... Nel forum Hardware, firmware and software help	7 years fa
	I had a similar problem a while back, it looked liked my hot... Nel forum Hardware, firmware and software help	7 years fa
	I guess i'll stop this print as well. I think i'm going to t... Nel forum Hardware, firmware and software help	7 years fa
	Try flashing newest firmware. I'm already running the new... Nel forum Hardware, firmware and software help	7 years fa
	Try flashing newest firmware. I'm already running the new... Nel forum Hardware, firmware and software help	7 years fa
	Hotend not heating up past 225. Nel forum Hardware, firmware and software help	7 years fa

Statistiche Forum

585 Forum

68.3 K Discussioni

478.1 K Post

12 Online

76 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso