Avisos
Vaciar todo
Logical Waste
Grupo: Registrado
Registrado: 2017/02/13
Active Member
1
|
Filament Runout Sensor triggers too late. En el foro Hardware, firmware and software help |
hace 7 years | |
|
Slice it again and set the fan to come on at layer 3. I'm go... En el foro Hardware, firmware and software help |
hace 7 years | |
|
The printer works fine at tempts 225 or below.
The very sec... En el foro Hardware, firmware and software help |
hace 7 years | |
|
I had a similar problem a while back, it looked liked my hot... En el foro Hardware, firmware and software help |
hace 7 years | |
|
I guess i'll stop this print as well. I think i'm going to t... En el foro Hardware, firmware and software help |
hace 7 years | |
|
Try flashing newest firmware.
I'm already running the new... En el foro Hardware, firmware and software help |
hace 7 years | |
|
Try flashing newest firmware.
I'm already running the new... En el foro Hardware, firmware and software help |
hace 7 years | |
|
Hotend not heating up past 225. En el foro Hardware, firmware and software help |
hace 7 years |