Notifications
Clear all
Logical Waste
Groupe: Enregistré
A(ont) rejoint: 2017/02/13
Active Member
1
|
Filament Runout Sensor triggers too late. Dans le forum Hardware, firmware and software help |
il y a 7 years | |
|
Slice it again and set the fan to come on at layer 3. I'm go... Dans le forum Hardware, firmware and software help |
il y a 7 years | |
|
The printer works fine at tempts 225 or below.
The very sec... Dans le forum Hardware, firmware and software help |
il y a 7 years | |
|
I had a similar problem a while back, it looked liked my hot... Dans le forum Hardware, firmware and software help |
il y a 7 years | |
|
I guess i'll stop this print as well. I think i'm going to t... Dans le forum Hardware, firmware and software help |
il y a 7 years | |
|
Try flashing newest firmware.
I'm already running the new... Dans le forum Hardware, firmware and software help |
il y a 7 years | |
|
Try flashing newest firmware.
I'm already running the new... Dans le forum Hardware, firmware and software help |
il y a 7 years | |
|
Hotend not heating up past 225. Dans le forum Hardware, firmware and software help |
il y a 7 years |