Prusa3D Forum

Notifications

Clear all

Logical Waste

Group: Registered

Joined: 2017/02/13

Active Member

	Filament Runout Sensor triggers too late. In forum Hardware, firmware and software help	7 years ago
	Slice it again and set the fan to come on at layer 3. I'm go... In forum Hardware, firmware and software help	7 years ago
	The printer works fine at tempts 225 or below. The very sec... In forum Hardware, firmware and software help	7 years ago
	I had a similar problem a while back, it looked liked my hot... In forum Hardware, firmware and software help	7 years ago
	I guess i'll stop this print as well. I think i'm going to t... In forum Hardware, firmware and software help	7 years ago
	Try flashing newest firmware. I'm already running the new... In forum Hardware, firmware and software help	7 years ago
	Try flashing newest firmware. I'm already running the new... In forum Hardware, firmware and software help	7 years ago
	Hotend not heating up past 225. In forum Hardware, firmware and software help	7 years ago

Forum Statistics

595 Forums

68.8 K Topics

481.5 K Posts

14 Online

77.4 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed