Prusa3D Forum

Notifications

Clear all

Lagersuufer

Groupe: Enregistré

A(ont) rejoint: 2023/04/05

Active Member

	My Experience is that it was not the nozzle. I did replace i... Dans le forum Assembly and first prints troubleshooting	il y a 3 months
	Trying to punch a hole into the side of a hollow object. Dans le forum PrusaSlicer	il y a 1 year
	So far on the new Beta firmware I have had zero issues. Two,... Dans le forum Hardware, firmware and software help	il y a 2 years
	I agree with you, but I think it has to do with multi-color ... Dans le forum Hardware, firmware and software help	il y a 2 years
	I don't think it is the USB drive itself. The error is the s... Dans le forum Hardware, firmware and software help	il y a 2 years
	I can confirm that it happens in 4.7.2 also. So far, Support... Dans le forum Hardware, firmware and software help	il y a 2 years
	I've also had this problem with both the 5.1 alpha2 and 4.7.... Dans le forum Hardware, firmware and software help	il y a 2 years
	I’m having the same problem. Just started today with a 14 ho... Dans le forum Hardware, firmware and software help	il y a 2 years
	Try raising your Z just a little bit. That should fix the f... Dans le forum How do I print this? (Printing help)	il y a 2 years

Statistiques du forum

585 Forums

68.2 K Sujets

477.9 K Messages

13 En-ligne

76 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé