Prusa3D Forum

Notifications

Clear all

Lagersuufer

Skupina: Registrovaný

Přidal se: 2023/04/05

Active Member

	My Experience is that it was not the nozzle. I did replace i... In forum Assembly and first prints troubleshooting	před 5 months
	Trying to punch a hole into the side of a hollow object. In forum PrusaSlicer	před 2 years
	So far on the new Beta firmware I have had zero issues. Two,... In forum Hardware, firmware and software help	před 2 years
	I agree with you, but I think it has to do with multi-color ... In forum Hardware, firmware and software help	před 2 years
	I don't think it is the USB drive itself. The error is the s... In forum Hardware, firmware and software help	před 2 years
	I can confirm that it happens in 4.7.2 also. So far, Support... In forum Hardware, firmware and software help	před 2 years
	I've also had this problem with both the 5.1 alpha2 and 4.7.... In forum Hardware, firmware and software help	před 2 years
	I’m having the same problem. Just started today with a 14 ho... In forum Hardware, firmware and software help	před 2 years
	Try raising your Z just a little bit. That should fix the f... In forum How do I print this? (Printing help)	před 3 years

Fórum Statistiky

595 Fóra

69.1 K Témata

483.4 K Příspěvky

13 Online

78.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed