Prusa3D Forum

Notifications

Clear all

kenb

Groupe: Enregistré

A(ont) rejoint: 2024/01/23

Active Member

	PrusaSlicer 2.8.1 and a mk4 upgraded to mk4s and i have thi... Dans le forum How do I print this? (Printing help)	il y a 3 weeks
	I have this problem too, with 2.8.0 on macos. Really screws... Dans le forum PrusaSlicer	il y a 6 months
	i had a similar ripple problem when using IS. the mk4 was on... Dans le forum Hardware, firmware and software help	il y a 10 months
	are the thread lengths supposed to be different? to solve yo... Dans le forum Input Shaper (MK4)	il y a 10 months
	perhaps this will help:which is the data sheet for the accel... Dans le forum Input Shaper (MK4)	il y a 10 months
	Yes, my face is red. I was in a hurry and it slipped my min... Dans le forum Assembly and first prints troubleshooting	il y a 11 months
	Thanks guys... I may have another problem: I tried printing... Dans le forum Assembly and first prints troubleshooting	il y a 11 months
	After several days, Prusa has still not replied to my suppor... Dans le forum Assembly and first prints troubleshooting	il y a 11 months
	Factory built MK4, first layer failures Dans le forum Assembly and first prints troubleshooting	il y a 11 months

Statistiques du forum

565 Forums

63.5 K Sujets

446 K Messages

21 En-ligne

68.8 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé