Prusa3D Forum

Avisos

Vaciar todo

kenb

Grupo: Registrado

Registrado: 2024/01/23

Active Member

	PrusaSlicer 2.8.1 and a mk4 upgraded to mk4s and i have thi... En el foro How do I print this? (Printing help)	hace 3 weeks
	I have this problem too, with 2.8.0 on macos. Really screws... En el foro PrusaSlicer	hace 6 months
	i had a similar ripple problem when using IS. the mk4 was on... En el foro Hardware, firmware and software help	hace 10 months
	are the thread lengths supposed to be different? to solve yo... En el foro Input Shaper (MK4)	hace 10 months
	perhaps this will help:which is the data sheet for the accel... En el foro Input Shaper (MK4)	hace 10 months
	Yes, my face is red. I was in a hurry and it slipped my min... En el foro Assembly and first prints troubleshooting	hace 11 months
	Thanks guys... I may have another problem: I tried printing... En el foro Assembly and first prints troubleshooting	hace 11 months
	After several days, Prusa has still not replied to my suppor... En el foro Assembly and first prints troubleshooting	hace 11 months
	Factory built MK4, first layer failures En el foro Assembly and first prints troubleshooting	hace 11 months

Estadísticas del Foro

565 Foros

63.5 K Temas

446 K Respuestas

22 En línea

68.8 K Miembros

Iconos del foro: El foro no contiene publicaciones sin leer El foro contiene publicaciones sin leer

Iconos de los Temas: No respondidos Respondido Activo Popular Fijo No aprobados Resuelto Privado Cerrado