|
I am also having this issue. Reported to [email protected].
... In forum Hardware, firmware and software help |
7 years ago |
|
Huh, I didn't even notice that there was an LED on the front... In forum Others (Archive) |
7 years ago |
|
I believe your issue is with the if/else statement in Slic3r... In forum Others (Archive) |
7 years ago |
|
Those of you that are having issues, what version of Slic3r ... In forum How do I print this? (Printing help) |
7 years ago |
|
I've been using PETG almost exclusively for the past year, a... In forum Others (Archive) |
7 years ago |
|
How to interpret calibration results In forum Others (Archive) |
7 years ago |
|
FWIW, I've always found the need to tune the extrusion multi... In forum Others (Archive) |
7 years ago |
|
Slic3r does not work correctly with non-manifold STLs. You s... In forum Print tips (Archive) |
7 years ago |
|
My printed part was fine... it is really snug in there.
You... In forum Others (Archive) |
7 years ago |
|
I ran into this issue too. Definitely too little infill in t... In forum Others (Archive) |
7 years ago |
|
Talked to support, they said this is reason to be replaced. ... In forum Hardware, firmware and software help |
7 years ago |
|
I've been struggling to find an in stock and reasonably pric... In forum Others (Archive) |
7 years ago |
|
If you're printing from octoprint I recommend keeping the fi... In forum User mods - OctoPrint, enclosures, nozzles, ... |
7 years ago |
|
Then later, I tweaked my x-axis belts to make them tighter. ... In forum Others (Archive) |
7 years ago |
|
The extruder stepper motor will always be much hotter than t... In forum Others (Archive) |
7 years ago |
|
I'm also experiencing noise from the PSU, but I'd describe i... In forum Others (Archive) |
7 years ago |
|
I would think the pins are the standard .025" square in a pl... In forum User mods - OctoPrint, enclosures, nozzles, ... |
7 years ago |
|
Be careful. Loctite is known to degrade most plastics. I'm n... In forum Others (Archive) |
7 years ago |
|
I'm having a difficult time finding header pins of the appro... In forum User mods - OctoPrint, enclosures, nozzles, ... |
7 years ago |
