|
Yes, I'll do that tomorrow. But I'm already afraid seeing th... In forum Hardware, firmware and software help |
2 weeks ago |
|
Here is a link to the lamp: I reduced the size bei 50%. Pri... In forum Hardware, firmware and software help |
2 weeks ago |
|
I printed the lampshade again today. It didn't work again. B... In forum Hardware, firmware and software help |
2 weeks ago |
|
Thanks for your help. I loosened the belts again. The gantry... In forum Hardware, firmware and software help |
2 weeks ago |
|
After readjusting the belt tension to 96/92Hz, I printed a c... In forum Hardware, firmware and software help |
3 weeks ago |
|
Yes, the X and Y calibrations always pass the test.
Initia... In forum Hardware, firmware and software help |
3 weeks ago |
|
I have a very similar problem. I finished my kit assembly la... In forum Hardware, firmware and software help |
3 weeks ago |
|
The noise is from the PWM control and exchaning the fan won'... In forum Others (Archive) |
8 years ago |
|
I still think the instructions for extruder idler spring ten... In forum Others (Archive) |
8 years ago |
|
I guess that is one of the reasons why the extruder ist prin... In forum Others (Archive) |
8 years ago |
|
Have got an replacement fan from Prusa, unfortunately still ... In forum Others (Archive) |
8 years ago |
|
I have the same problems (only with layer hights < 0.1). ... In forum Others (Archive) |
8 years ago |
|
do you guys have the left hand fan on the right way round?
t... In forum Others (Archive) |
8 years ago |
|
Prusa have assured everyone that the motors are designed and... In forum Others (Archive) |
8 years ago |
|
I wrote the support and they told me to lower the pressure t... In forum Others (Archive) |
8 years ago |
|
It's possible that it is normal, but that will not mean that... In forum Others (Archive) |
8 years ago |
|
I observe exactly the same when I try to print at 0.1 layer ... In forum Others (Archive) |
8 years ago |
|
At which layer hight you try to print? I have the same probl... In forum Others (Archive) |
8 years ago |
|
I placed tiny ball bearings I had laying around for 20 years... In forum Others (Archive) |
8 years ago |
