Prusa3D Forum

Notifications

Clear all

Kakemanx

Grupa: Zarejestrowany

Dołączył: 2016/12/30

Active Member

	I just found that the signal cable to the PINDA is broken.. ... In forum Others (Archive)	8 years temu
	My dearest is acting up.. In forum Others (Archive)	8 years temu
	Layer addhesion In forum Others (Archive)	9 years temu
	To be honest... don't know.. i just do it be "looks perfect-... In forum Others (Archive)	9 years temu
	in my oppinion this is part of the 3d printing hobby 🙂 I kn... In forum Others (Archive)	9 years temu
	has the z distanced changed for some reason.. is there enoug... In forum Others (Archive)	9 years temu
	stick to the supplied PLA and one of the supplied allready s... In forum Others (Archive)	9 years temu
	Yes, sorry for my bad description 😛 Those are the ones... ... In forum Others (Archive)	9 years temu
	Yes, i have done this, but seems the z screw is restricted f... In forum Others (Archive)	9 years temu
	Left side higher then right side... In forum Others (Archive)	9 years temu
	because, according to what i read it does have a tendency to... In forum Others (Archive)	9 years temu
	Have been using servo and probe on my previous printers, ord... In forum Others (Archive)	9 years temu
	PINDA probe out of the way? In forum Others (Archive)	9 years temu

Statystyki Forum

585 Fora

68.1 K Tematy

477.2 K Posty

14 Online

75.8 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte