Prusa3D Forum

Notifications

Clear all

Kakemanx

Groupe: Enregistré

A(ont) rejoint: 2016/12/30

Active Member

	I just found that the signal cable to the PINDA is broken.. ... Dans le forum Others (Archive)	il y a 7 years
	My dearest is acting up.. Dans le forum Others (Archive)	il y a 7 years
	Layer addhesion Dans le forum Others (Archive)	il y a 8 years
	To be honest... don't know.. i just do it be "looks perfect-... Dans le forum Others (Archive)	il y a 8 years
	in my oppinion this is part of the 3d printing hobby 🙂 I kn... Dans le forum Others (Archive)	il y a 8 years
	has the z distanced changed for some reason.. is there enoug... Dans le forum Others (Archive)	il y a 8 years
	stick to the supplied PLA and one of the supplied allready s... Dans le forum Others (Archive)	il y a 8 years
	Yes, sorry for my bad description 😛 Those are the ones... ... Dans le forum Others (Archive)	il y a 8 years
	Yes, i have done this, but seems the z screw is restricted f... Dans le forum Others (Archive)	il y a 8 years
	Left side higher then right side... Dans le forum Others (Archive)	il y a 8 years
	because, according to what i read it does have a tendency to... Dans le forum Others (Archive)	il y a 8 years
	Have been using servo and probe on my previous printers, ord... Dans le forum Others (Archive)	il y a 8 years
	PINDA probe out of the way? Dans le forum Others (Archive)	il y a 8 years

Statistiques du forum

559 Forums

63.1 K Sujets

443.9 K Messages

21 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé