Prusa3D Forum

Notifiche

Cancella tutti

Kakemanx

Gruppo: Registrato

Registrato: 2016/12/30

Active Member

	I just found that the signal cable to the PINDA is broken.. ... Nel forum Others (Archive)	7 years fa
	My dearest is acting up.. Nel forum Others (Archive)	7 years fa
	Layer addhesion Nel forum Others (Archive)	8 years fa
	To be honest... don't know.. i just do it be "looks perfect-... Nel forum Others (Archive)	8 years fa
	in my oppinion this is part of the 3d printing hobby 🙂 I kn... Nel forum Others (Archive)	8 years fa
	has the z distanced changed for some reason.. is there enoug... Nel forum Others (Archive)	8 years fa
	stick to the supplied PLA and one of the supplied allready s... Nel forum Others (Archive)	8 years fa
	Yes, sorry for my bad description 😛 Those are the ones... ... Nel forum Others (Archive)	8 years fa
	Yes, i have done this, but seems the z screw is restricted f... Nel forum Others (Archive)	8 years fa
	Left side higher then right side... Nel forum Others (Archive)	8 years fa
	because, according to what i read it does have a tendency to... Nel forum Others (Archive)	8 years fa
	Have been using servo and probe on my previous printers, ord... Nel forum Others (Archive)	8 years fa
	PINDA probe out of the way? Nel forum Others (Archive)	8 years fa

Statistiche Forum

559 Forum

63.1 K Discussioni

443.9 K Post

20 Online

68.1 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso