Prusa3D Forum

Notifications

Clear all

kageryu

Grupa: Zarejestrowany

Dołączył: 2021/12/07

Active Member

	I just received an email from Prusa support on this. For an... In forum Hardware, firmware and software help	2 years temu
	Are M3x12b screws the same as M3X12? In forum Hardware, firmware and software help	2 years temu
	Here is a look at my probe points with a second run, do they... In forum PrusaSlicer	2 years temu
	I wonder if the nylock nut mod did some damage to my bed. T... In forum PrusaSlicer	2 years temu
	Thanks to everyone for their advice. I will try to print ou... In forum PrusaSlicer	2 years temu
	I do wash my plate and use IPA before every print. I've not... In forum PrusaSlicer	2 years temu
	I tried printing out the handle again by increasing the brim... In forum PrusaSlicer	2 years temu
	I'm not sure the attachment made it. I'm going to try again... In forum PrusaSlicer	2 years temu
	It goes away if I remove the raft, so I think the raft is ca... In forum PrusaSlicer	2 years temu
	Will do and thanks for looking. In forum PrusaSlicer	2 years temu
	Attached is the project file. This is a handle for my scree... In forum PrusaSlicer	2 years temu
	Trying out popular raft settings - Warning Message In forum PrusaSlicer	2 years temu
	Thank you In forum PrusaSlicer	3 years temu
	I'm fine with playing around with the stock start/end g-code... In forum PrusaSlicer	3 years temu
	Help Converting Cura Start/End G-Code for Ender 5 Plus In forum PrusaSlicer	3 years temu

Statystyki Forum

559 Fora

63 K Tematy

443.6 K Posty

20 Online

67.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte