Prusa3D Forum

Notifications

Clear all

kageryu

Skupina: Registrovaný

Přidal se: 2021/12/07

Active Member

	I just received an email from Prusa support on this. For an... In forum Hardware, firmware and software help	před 2 years
	Are M3x12b screws the same as M3X12? In forum Hardware, firmware and software help	před 2 years
	Here is a look at my probe points with a second run, do they... In forum PrusaSlicer	před 3 years
	I wonder if the nylock nut mod did some damage to my bed. T... In forum PrusaSlicer	před 3 years
	Thanks to everyone for their advice. I will try to print ou... In forum PrusaSlicer	před 3 years
	I do wash my plate and use IPA before every print. I've not... In forum PrusaSlicer	před 3 years
	I tried printing out the handle again by increasing the brim... In forum PrusaSlicer	před 3 years
	I'm not sure the attachment made it. I'm going to try again... In forum PrusaSlicer	před 3 years
	It goes away if I remove the raft, so I think the raft is ca... In forum PrusaSlicer	před 3 years
	Will do and thanks for looking. In forum PrusaSlicer	před 3 years
	Attached is the project file. This is a handle for my scree... In forum PrusaSlicer	před 3 years
	Trying out popular raft settings - Warning Message In forum PrusaSlicer	před 3 years
	Thank you In forum PrusaSlicer	před 3 years
	I'm fine with playing around with the stock start/end g-code... In forum PrusaSlicer	před 3 years
	Help Converting Cura Start/End G-Code for Ender 5 Plus In forum PrusaSlicer	před 3 years

Fórum Statistiky

559 Fóra

63.1 K Témata

444 K Příspěvky

19 Online

68 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed