Prusa3D Forum

Notifications

Clear all

kageryu

Groupe: Enregistré

A(ont) rejoint: 2021/12/07

Active Member

	I just received an email from Prusa support on this. For an... Dans le forum Hardware, firmware and software help	il y a 2 years
	Are M3x12b screws the same as M3X12? Dans le forum Hardware, firmware and software help	il y a 2 years
	Here is a look at my probe points with a second run, do they... Dans le forum PrusaSlicer	il y a 3 years
	I wonder if the nylock nut mod did some damage to my bed. T... Dans le forum PrusaSlicer	il y a 3 years
	Thanks to everyone for their advice. I will try to print ou... Dans le forum PrusaSlicer	il y a 3 years
	I do wash my plate and use IPA before every print. I've not... Dans le forum PrusaSlicer	il y a 3 years
	I tried printing out the handle again by increasing the brim... Dans le forum PrusaSlicer	il y a 3 years
	I'm not sure the attachment made it. I'm going to try again... Dans le forum PrusaSlicer	il y a 3 years
	It goes away if I remove the raft, so I think the raft is ca... Dans le forum PrusaSlicer	il y a 3 years
	Will do and thanks for looking. Dans le forum PrusaSlicer	il y a 3 years
	Attached is the project file. This is a handle for my scree... Dans le forum PrusaSlicer	il y a 3 years
	Trying out popular raft settings - Warning Message Dans le forum PrusaSlicer	il y a 3 years
	Thank you Dans le forum PrusaSlicer	il y a 3 years
	I'm fine with playing around with the stock start/end g-code... Dans le forum PrusaSlicer	il y a 3 years
	Help Converting Cura Start/End G-Code for Ender 5 Plus Dans le forum PrusaSlicer	il y a 3 years

Statistiques du forum

559 Forums

63.1 K Sujets

444 K Messages

18 En-ligne

68 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé