Prusa3D Forum

Notifications

Clear all

Justin

Groupe: Enregistré

A(ont) rejoint: 2020/05/19

Active Member

	@bobstro I think this is the fix. I had toyed with going low... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@tim-m30 Yep, looks to within +/- 0.01 Dans le forum How do I print this? (Printing help)	il y a 4 years
	If I switch from rectilinear to concentric solid bottom laye... Dans le forum How do I print this? (Printing help)	il y a 4 years
	@joantabb Thanks Joan but that doesn't seem to help. I went ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Dot gaps in first layer at walls Dans le forum How do I print this? (Printing help)	il y a 4 years
	For reference:/p> Dans le forum Hardware, firmware and software help	il y a 4 years
	@crawlerin Thank you! Will check out their github page. Dans le forum Hardware, firmware and software help	il y a 4 years
	Is anyone from Prusa patrolling the forums? Should I email t... Dans le forum Hardware, firmware and software help	il y a 4 years
	Nozzle hits bed alignment screws for large print during skir... Dans le forum Hardware, firmware and software help	il y a 4 years
	@herbert Great idea. I just used the first post code on my n... Dans le forum Assembly and first prints troubleshooting	il y a 5 years

Statistiques du forum

565 Forums

63.6 K Sujets

446.1 K Messages

20 En-ligne

68.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé