Prusa3D Forum

Notifications

Clear all

Justin

Skupina: Registrovaný

Přidal se: 2020/05/19

Active Member

	@bobstro I think this is the fix. I had toyed with going low... In forum How do I print this? (Printing help)	před 4 years
	@tim-m30 Yep, looks to within +/- 0.01 In forum How do I print this? (Printing help)	před 4 years
	If I switch from rectilinear to concentric solid bottom laye... In forum How do I print this? (Printing help)	před 4 years
	@joantabb Thanks Joan but that doesn't seem to help. I went ... In forum How do I print this? (Printing help)	před 4 years
	Dot gaps in first layer at walls In forum How do I print this? (Printing help)	před 4 years
	For reference:/p> In forum Hardware, firmware and software help	před 4 years
	@crawlerin Thank you! Will check out their github page. In forum Hardware, firmware and software help	před 4 years
	Is anyone from Prusa patrolling the forums? Should I email t... In forum Hardware, firmware and software help	před 4 years
	Nozzle hits bed alignment screws for large print during skir... In forum Hardware, firmware and software help	před 4 years
	@herbert Great idea. I just used the first post code on my n... In forum Assembly and first prints troubleshooting	před 5 years

Fórum Statistiky

565 Fóra

63.6 K Témata

446.1 K Příspěvky

22 Online

68.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed