Prusa3D Forum

Benachrichtigungen

Alles löschen

Justin

Gruppe: Registriert

Beigetreten: 2020/05/19

Active Member

	@bobstro I think this is the fix. I had toyed with going low... Im Forum How do I print this? (Printing help)	Vor 4 years
	@tim-m30 Yep, looks to within +/- 0.01 Im Forum How do I print this? (Printing help)	Vor 4 years
	If I switch from rectilinear to concentric solid bottom laye... Im Forum How do I print this? (Printing help)	Vor 4 years
	@joantabb Thanks Joan but that doesn't seem to help. I went ... Im Forum How do I print this? (Printing help)	Vor 4 years
	Dot gaps in first layer at walls Im Forum How do I print this? (Printing help)	Vor 4 years
	For reference:/p> Im Forum Hardware, firmware and software help	Vor 4 years
	@crawlerin Thank you! Will check out their github page. Im Forum Hardware, firmware and software help	Vor 4 years
	Is anyone from Prusa patrolling the forums? Should I email t... Im Forum Hardware, firmware and software help	Vor 4 years
	Nozzle hits bed alignment screws for large print during skir... Im Forum Hardware, firmware and software help	Vor 4 years
	@herbert Great idea. I just used the first post code on my n... Im Forum Assembly and first prints troubleshooting	Vor 5 years

Forums-Statistiken

565 Foren

63.6 K Themen

446.1 K Beiträge

25 Online

68.9 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen