Notifications
Clear all
jsawyer
Skupina: Registrovaný
Přidal se: 2021/05/12
Eminent Member
2
| Not so far. I am running a couple of tests today to see if t... | před 3 years | |
|
Bad GCode In forum Hardware, firmware and software help |
před 3 years | |
| I have been printing PETG with PLA for support and it works ... | před 3 years | |
| I had issues getting filament loaded until I noticed that th... | před 3 years | |
|
I had issues with the socks not fitting all the way on. I s... In forum Hardware, firmware and software help |
před 3 years | |
|
I had that happen a couple of times with mine. It has not do... In forum Hardware, firmware and software help |
před 3 years | |
| Yes, I am using the stock .6 nozzles. I have a pair of .4 b... | před 3 years | |
| That is after 15 hours at 45C in a dehydrator. I do not ge... | před 3 years | |
| I have tried drying the spools I have, I just ordered and re... | před 3 years | |
| Stringing Issues | před 3 years | |
|
I am seeing this error on one of my printers. It looks like ... In forum Hardware, firmware and software help |
před 5 years |
Stránka 2 / 2
Předchozí