English
Forums
Members
Jonathan Newman
Activity
 
Notifications
Clear all
Jonathan Newman
Jonathan Newman
Group: Registered
Joined: 2018/11/13
Active Member
1
Profile Activity
Right now I'm most concerned that the 3.5 does not have a dr...

In forum Assembly and first prints troubleshooting

 11 months ago
Where did you get the cable from?

In forum Hardware, firmware and software help

 11 months ago
That's a fair statement. But I believe it argues the other s...

In forum Assembly and first prints troubleshooting

 11 months ago
Yep on my MK3.9 Printing without InputShaper is done by usin...

In forum Input Shaper (MK3.9)

 11 months ago
Yeah this is a MK3.5 issue. the MK4 and MK3.9 both have a re...

In forum Hardware, firmware and software help

 11 months ago
I've got a MW LRS350, from your PE cable perspective you wil...

In forum Hardware, firmware and software help

 11 months ago
I just email support on this. it seems a shame to loose half...

In forum Assembly and first prints troubleshooting

 11 months ago
All five of the default settings there are input shaper prof...

In forum Assembly and first prints troubleshooting

 11 months ago
MK3.5 Non-Input Shaper Profile

In forum Assembly and first prints troubleshooting

 11 months ago
I ended up buying all the parts needed to upgrade my Bear to...

In forum General discussion, announcements and releases

 1 year ago
What to do with the old parts?

In forum General discussion, announcements and releases

 1 year ago
Are the new 10mm z-rods included ? I went ahead and ordered ...

In forum General discussion, announcements and releases

 1 year ago
The print head needs to be MUCH lower for the first layer. O...

In forum Assembly and first prints troubleshooting

 4 years ago
Share: