Italiano
Forum
Utenti
john.f5
Attività
 
Notifiche
Cancella tutti
john.f5
john.f5
Gruppo: Registrato
Registrato: 2016/11/28
Eminent Member
2
Profilo Attività
I don't see a mk2 to mk2S upgrade kit offered. Am I just mi...

Nel forum Assembly and first prints troubleshooting

 5 years fa
So the 2 to 2S will give me new rods and bearings. Can I do...

Nel forum Assembly and first prints troubleshooting

 5 years fa
Upgrade jitters

Nel forum Assembly and first prints troubleshooting

 5 years fa
Copperfill issues, and clogging

Nel forum Others (Archive)

 7 years fa
I didn't try it the other way. I was under the impression t...

Nel forum Others (Archive)

 8 years fa
PTFE tube issue

Nel forum Others (Archive)

 8 years fa
ABS shrinkage

Nel forum Others (Archive)

 8 years fa
What else to print?

Nel forum Others (Archive)

 8 years fa
Hi all, I ended up pulling the extruder out again, and repla...

Nel forum Prusa i3 kit (Archive)

 8 years fa
Clogged again

Nel forum Prusa i3 kit (Archive)

 8 years fa
Thanks that was exactly what I needed. I had two of the scr...

Nel forum Prusa i3 kit (Archive)

 8 years fa
Screws don't tighten

Nel forum Prusa i3 kit (Archive)

 8 years fa
Thanks for the link. Great to see someone else try it first...

Nel forum Prusa i3 kit (Archive)

 8 years fa
How do I get the hot end out?

Nel forum Prusa i3 kit (Archive)

 8 years fa
I heated up the extruder and poked the needle up. It hits s...

Nel forum Hardware, firmware and software help

 8 years fa
Filament break, can't unload

Nel forum Hardware, firmware and software help

 8 years fa
I didn't build it, but the grub looks correct. belt is taug...

Nel forum Ostatní (Archiv)

 8 years fa
X slip

Nel forum Ostatní (Archiv)

 8 years fa
Is there a lubrication requirement?

Nel forum Others (Archive)

 8 years fa
Ok, I got it off. But, that wasted a good hour of my playti...

Nel forum Ostatní (Archiv)

 8 years fa
Pagina 1 / 2
Condividi: