English
Forums
Members
john.f5
Activity
 
Notifications
Clear all
john.f5
john.f5
Group: Registered
Joined: 2016/11/28
Eminent Member
2
Profile Activity
I don't see a mk2 to mk2S upgrade kit offered. Am I just mi...

In forum Assembly and first prints troubleshooting

 5 years ago
So the 2 to 2S will give me new rods and bearings. Can I do...

In forum Assembly and first prints troubleshooting

 5 years ago
Upgrade jitters

In forum Assembly and first prints troubleshooting

 5 years ago
Copperfill issues, and clogging

In forum Others (Archive)

 7 years ago
I didn't try it the other way. I was under the impression t...

In forum Others (Archive)

 8 years ago
PTFE tube issue

In forum Others (Archive)

 8 years ago
ABS shrinkage

In forum Others (Archive)

 8 years ago
What else to print?

In forum Others (Archive)

 8 years ago
Hi all, I ended up pulling the extruder out again, and repla...

In forum Prusa i3 kit (Archive)

 8 years ago
Clogged again

In forum Prusa i3 kit (Archive)

 8 years ago
Thanks that was exactly what I needed. I had two of the scr...

In forum Prusa i3 kit (Archive)

 8 years ago
Screws don't tighten

In forum Prusa i3 kit (Archive)

 8 years ago
Thanks for the link. Great to see someone else try it first...

In forum Prusa i3 kit (Archive)

 8 years ago
How do I get the hot end out?

In forum Prusa i3 kit (Archive)

 8 years ago
I heated up the extruder and poked the needle up. It hits s...

In forum Hardware, firmware and software help

 8 years ago
Filament break, can't unload

In forum Hardware, firmware and software help

 8 years ago
I didn't build it, but the grub looks correct. belt is taug...

In forum Ostatní (Archiv)

 8 years ago
X slip

In forum Ostatní (Archiv)

 8 years ago
Is there a lubrication requirement?

In forum Others (Archive)

 8 years ago
Ok, I got it off. But, that wasted a good hour of my playti...

In forum Ostatní (Archiv)

 8 years ago
Page 1 / 2
Share: