Deutsch
Foren
Mitglieder
john.f5
Aktivität
 
Benachrichtigungen
Alles löschen
john.f5
john.f5
Gruppe: Registriert
Beigetreten: 2016/11/28
Eminent Member
2
Profil Aktivität
I don't see a mk2 to mk2S upgrade kit offered. Am I just mi...

Im Forum Assembly and first prints troubleshooting

 Vor 5 years
So the 2 to 2S will give me new rods and bearings. Can I do...

Im Forum Assembly and first prints troubleshooting

 Vor 5 years
Upgrade jitters

Im Forum Assembly and first prints troubleshooting

 Vor 5 years
Copperfill issues, and clogging

Im Forum Others (Archive)

 Vor 7 years
I didn't try it the other way. I was under the impression t...

Im Forum Others (Archive)

 Vor 8 years
PTFE tube issue

Im Forum Others (Archive)

 Vor 8 years
ABS shrinkage

Im Forum Others (Archive)

 Vor 8 years
What else to print?

Im Forum Others (Archive)

 Vor 8 years
Hi all, I ended up pulling the extruder out again, and repla...

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
Clogged again

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
Thanks that was exactly what I needed. I had two of the scr...

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
Screws don't tighten

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
Thanks for the link. Great to see someone else try it first...

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
How do I get the hot end out?

Im Forum Prusa i3 kit (Archive)

 Vor 8 years
I heated up the extruder and poked the needle up. It hits s...

Im Forum Hardware, firmware and software help

 Vor 8 years
Filament break, can't unload

Im Forum Hardware, firmware and software help

 Vor 8 years
I didn't build it, but the grub looks correct. belt is taug...

Im Forum Ostatní (Archiv)

 Vor 8 years
X slip

Im Forum Ostatní (Archiv)

 Vor 8 years
Is there a lubrication requirement?

Im Forum Others (Archive)

 Vor 8 years
Ok, I got it off. But, that wasted a good hour of my playti...

Im Forum Ostatní (Archiv)

 Vor 8 years
Seite 1 / 2
Teilen: