Čeština
Fóra
Uživatelé
jF
Aktivita
 
Notifications
Clear all
jF
jF
Skupina: Registrovaný
Přidal se: 2020/10/09
Trusted Member
3
Profile Aktivita
Both grub screws for the pully on the right motor were compl...

In forum Assembly and first prints troubleshooting

 před 1 year
Belt Tension Error and Toolhead crashing

In forum Assembly and first prints troubleshooting

 před 1 year
But how is this still not available almost two years later ....

In forum General discussion, announcements and releases

 před 3 years
There's a recent firmware alpha release that supposedly addr...

In forum Hardware, firmware and software help

 před 4 years
You should really try it with PETG. I also only print PETG a...

In forum Hardware, firmware and software help

 před 4 years
Étrangement de mon coté ma Prusa Mini n'a été que du bonheur...

In forum Hardware, firmware and software help

 před 4 years
Seem to be a new beta frimware that solves the issue. No ide...

In forum Hardware, firmware and software help

 před 4 years
Does Octoprint work with the mini? I searched a bit yesterda...

In forum Hardware, firmware and software help

 před 4 years
Had the same issue as OP with the Katana retractable model. ...

In forum Assembly and first prints troubleshooting

 před 4 years
My dog always had a lot of separation issues but he got kind...

In forum Coronavirus (COVID-19)

 před 4 years
Got my mini today and had the same issue, it turn out to als...

In forum Hardware, firmware and software help

 před 4 years
Got my mini today and had the same issue, it turn out to als...

In forum Hardware, firmware and software help

 před 4 years
Got my mini today and had the same issue, it turn out to als...

In forum Hardware, firmware and software help

 před 4 years
Stránka 3 / 3
Share: