Polski
Fora
Członkowie
JDre357
Aktywność
 
Notifications
Clear all
JDre357
JDre357
Grupa: Zarejestrowany
Dołączył: 2017/01/05
Active Member
1
Profil Aktywność
I’m don’t know how to monitor the pinda temp value in the gc...

In forum Others (Archive)

 7 years temu
I’m interested to see if anyone has advice on how to fix thi...

In forum Others (Archive)

 7 years temu
I home all the axes, heat my bed to 60ºC and extruder to 150...

In forum Others (Archive)

 7 years temu
I had been having this problem for quite a while and actuall...

In forum Others (Archive)

 7 years temu
Bed Leveling / First Layer Issue

In forum Others (Archive)

 7 years temu
I had a similar issue with my MK3 extruder squeaking tonight...

In forum Others (Archive)

 7 years temu
I tried to compensate for this in my starting script. I even...

In forum Others (Archive)

 7 years temu
I’ve adjusted the live z. The print is great on the second t...

In forum Others (Archive)

 7 years temu
Poor First Layer Quality on First Attempt

In forum Others (Archive)

 7 years temu
I was just looking at my failed cylinder when I noticed that...

In forum Others (Archive)

 8 years temu
Looking at the images from the tubes and the headphone rest,...

In forum Others (Archive)

 8 years temu
I did check the cable harness. I put my extruder in the posi...

In forum Others (Archive)

 8 years temu
The print that failed a couple weeks ago had a large base an...

In forum Others (Archive)

 8 years temu
Tall Prints Fail

In forum Others (Archive)

 8 years temu
Oh ok. I'll give slic3r a shot and see how it compares. Than...

In forum Others (Archive)

 8 years temu
I appreciate the advice guys. By increasing my retraction di...

In forum Others (Archive)

 8 years temu
Are there certain parameters in S3D I can adjust that would ...

In forum Others (Archive)

 8 years temu
Stringing Problem

In forum Others (Archive)

 8 years temu
Share: