Prusa3D Forum

Notifications

Clear all

JDre357

Groupe: Enregistré

A(ont) rejoint: 2017/01/05

Active Member

	I’m don’t know how to monitor the pinda temp value in the gc... Dans le forum Others (Archive)	il y a 7 years
	I’m interested to see if anyone has advice on how to fix thi... Dans le forum Others (Archive)	il y a 7 years
	I home all the axes, heat my bed to 60ºC and extruder to 150... Dans le forum Others (Archive)	il y a 7 years
	I had been having this problem for quite a while and actuall... Dans le forum Others (Archive)	il y a 7 years
	Bed Leveling / First Layer Issue Dans le forum Others (Archive)	il y a 7 years
	I had a similar issue with my MK3 extruder squeaking tonight... Dans le forum Others (Archive)	il y a 7 years
	I tried to compensate for this in my starting script. I even... Dans le forum Others (Archive)	il y a 7 years
	I’ve adjusted the live z. The print is great on the second t... Dans le forum Others (Archive)	il y a 7 years
	Poor First Layer Quality on First Attempt Dans le forum Others (Archive)	il y a 7 years
	I was just looking at my failed cylinder when I noticed that... Dans le forum Others (Archive)	il y a 8 years
	Looking at the images from the tubes and the headphone rest,... Dans le forum Others (Archive)	il y a 8 years
	I did check the cable harness. I put my extruder in the posi... Dans le forum Others (Archive)	il y a 8 years
	The print that failed a couple weeks ago had a large base an... Dans le forum Others (Archive)	il y a 8 years
	Tall Prints Fail Dans le forum Others (Archive)	il y a 8 years
	Oh ok. I'll give slic3r a shot and see how it compares. Than... Dans le forum Others (Archive)	il y a 8 years
	I appreciate the advice guys. By increasing my retraction di... Dans le forum Others (Archive)	il y a 8 years
	Are there certain parameters in S3D I can adjust that would ... Dans le forum Others (Archive)	il y a 8 years
	Stringing Problem Dans le forum Others (Archive)	il y a 8 years

Statistiques du forum

565 Forums

64.3 K Sujets

450.3 K Messages

19 En-ligne

70.6 K Membres

Le dernier des messages: debris on print bed Notre nouveau membre: Sn3akyP3t3 Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé