Prusa3D Forum

Notifications

Clear all

Jake

Groupe: Enregistré

A(ont) rejoint: 2024/02/15

Active Member

	FYI the 5.2.2 firmware is out which fixes this issue, I upgr... Dans le forum Hardware, firmware and software help	il y a 11 months
	It really depends on the size of the part and your settings.... Dans le forum General discussion, announcements and releases	il y a 11 months
	When you say without issues what do you mean? I printed it o... Dans le forum Assembly and first prints troubleshooting	il y a 11 months
	I did some research into that and I read something about how... Dans le forum Assembly and first prints troubleshooting	il y a 12 months
	I just upgraded a mk3s and I had to loosen my x axis belt te... Dans le forum Assembly and first prints troubleshooting	il y a 12 months
	The Mk3S has a lot more print time on it, I figured I'd just... Dans le forum General discussion, announcements and releases	il y a 12 months
	Cool, thanks for the reply. I'll just keep them as spares. Dans le forum General discussion, announcements and releases	il y a 1 year
	Is swapping a MK3S+ board to MK3S worth the work? Dans le forum General discussion, announcements and releases	il y a 1 year

Statistiques du forum

565 Forums

64.5 K Sujets

451.7 K Messages

24 En-ligne

71.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé