Español
Foros
Miembros
ImAlias
Actividad
 
Avisos
Vaciar todo
ImAlias
ImAlias
Grupo: Registrado
Registrado: 2022/08/30
Active Member
1
Perfil Actividad
I'm not quite up to speed. I did this and it worked fine - ...

En el foro PrusaSlicer

 hace 3 months
Never mind - I see what I did wrong. Thanks for the help

En el foro PrusaSlicer

 hace 3 months
I'm sure you're right but maybe I'm missing some setting som...

En el foro PrusaSlicer

 hace 3 months
Why is there an option to change the Z position in the slice...

En el foro PrusaSlicer

 hace 3 months
Simple slicer question

En el foro PrusaSlicer

 hace 3 months
I got a thermal error after about 19 hours of printing. Thi...

En el foro How do I print this? (Printing help)

 hace 9 months
Send: N18101 G1 X85.309 Y108.021 E.01332*101 Recv: ok Send: ...

En el foro Hardware, firmware and software help

 hace 11 months
2 seconds after I posted that I got another M112 error.

En el foro Hardware, firmware and software help

 hace 11 months
Recent temperature fluctuations

En el foro Hardware, firmware and software help

 hace 11 months
Persistent leak

En el foro Hardware, firmware and software help

 hace 2 years
Can’t remove previous print image from bed.

En el foro Hardware, firmware and software help

 hace 2 years
Is this a clog?

En el foro Hardware, firmware and software help

 hace 3 years
And is there a way to see the supports in Prusa Slicer? If ...

En el foro How do I print this? (Printing help)

 hace 3 years
Do I need supports if I print the individual pieces?

En el foro How do I print this? (Printing help)

 hace 3 years
OK but are there simple instructions that say click here, ty...

En el foro How do I print this? (Printing help)

 hace 3 years
Is this too complicated for me?

En el foro How do I print this? (Printing help)

 hace 3 years
Ooops. I can't get all the nearly invisible PETG off the smo...

En el foro General discussion, announcements and releases

 hace 3 years
Compartir: