Notifications
Clear all
Illusionist
Illusionist
Skupina: Registrovaný
Přidal se: 2022/12/02
Eminent Member
2
hard to describe the issue, but i will try to explain: 1) ...

In forum General discussion, announcements and releases

před 8 months
Thanks to your answer and questions a) of course i have used...

In forum General discussion, announcements and releases

před 8 months
layershift laayershift laayeershift

In forum General discussion, announcements and releases

před 8 months
You are right ! i made all these steps, and all axis are pas...

In forum General discussion, announcements and releases

před 11 months
After 2 days analysing the issue, and it was a lot of work b...

In forum General discussion, announcements and releases

před 11 months
Miroslav, believe it or not, but i went trough all those tre...

In forum Hardware, firmware and software help

před 11 months
same layershifts here, since FW 5.0.1, and now with the new ...

In forum Input Shaper (MK4)

před 11 months
i guess you are right, but the issue is going much deeper: s...

In forum General discussion, announcements and releases

před 11 months
i do not believe that this is the answer - it is fully depen...

In forum General discussion, announcements and releases

před 11 months
Not sure if anybody else has the issue, that with the update...

In forum General discussion, announcements and releases

před 11 months
Thank you very much Russ,- so I will wait for another update...

In forum Hardware, firmware and software help

před 11 months
y axis fails afer FW update

In forum Hardware, firmware and software help

před 11 months
Servus Blauzahn, Dieses Layershifting trat unter der alpha...

In forum Hilfe zur Hardware, Firmware und Software

před 1 year
Ähm, i had the same issue some days ago. For me the cause wa...

In forum Assembly and first prints troubleshooting

před 1 year
Tja, mein Problem ist nur, dass ich mich nicht vergriffen ha...

In forum Hilfe zur Hardware, Firmware und Software

před 1 year
Habe das gleiche Problem und der Chat-Support hat leider auc...

In forum Hilfe zur Hardware, Firmware und Software

před 1 year
Unfassbar schlechte Software

In forum Hilfe zur Hardware, Firmware und Software

před 1 year
no solution ?? really ? Why is it not possible to load filla...

In forum Assembly and first prints troubleshooting

před 1 year
Loading Filament PA12

In forum Assembly and first prints troubleshooting

před 1 year
ordering of spare parts

In forum General discussion, announcements and releases

před 2 years
Share: