Čeština
Fóra
Uživatelé
hyiger
Aktivita
 
Notifications
Clear all
hyiger
hyiger
Skupina: Registrovaný
Přidal se: 2025/07/14
Noble Member
3
Profile Aktivita
Usually (and in my case) the Y motor was already grounded. C...

In forum Hardware, firmware and software help

 před 7 months
Try a different memory stick. The ones supplied by Prusa see...

In forum Hardware, firmware and software help

 před 7 months
Same problem, did many prints successfully until I tried one...

In forum Hardware, firmware and software help

 před 7 months
First week using Core One, lots of issues. Some tips for peo...

In forum Hardware, firmware and software help

 před 7 months
I asked the same of Prusa tech support and they replied with...

In forum Hardware, firmware and software help

 před 7 months
Problem with brand new Prusa Satin plate

In forum Assembly and first prints troubleshooting

 před 7 months
Thanks. I was in expert mode but neglected to scroll down. I...

In forum Assembly and first prints troubleshooting

 před 7 months
When changing colors mid-print, the filament oozes out of no...

In forum Assembly and first prints troubleshooting

 před 7 months
It's a brand new sheet from Prusa and I've only done 2 print...

In forum Assembly and first prints troubleshooting

 před 7 months
Upgraded my MK4S to Core One and getting waves in the first ...

In forum Assembly and first prints troubleshooting

 před 7 months
I went with gluing them on with Gorilla Glue Clear Grip. Bon...

In forum Assembly and first prints troubleshooting

 před 7 months
Yup, it was only a fluke. Adding the gcode patch worked for ...

In forum Assembly and first prints troubleshooting

 před 7 months
I completed the MK4S to CORE ONE conversion with 6.3.3 firmw...

In forum Assembly and first prints troubleshooting

 před 7 months
Stránka 103 / 103
Share: