Prusa3D Forum

Notifications

Clear all

hillinator

Grupa: Zarejestrowany

Dołączył: 2017/12/07

Active Member

	howdy folks. I had this issue last night with a new hotend f... In forum Hardware, firmware and software help	4 months temu
	"avoid crossing perimeters" Jams up Slic3r while s... In forum Others (Archive)	7 years temu
	I assumed the word "meticulously" implied I had tried cleani... In forum Others (Archive)	7 years temu
	found it!! if you load the generic MK2 profiles in slic3r yo... In forum Others (Archive)	7 years temu
	I’ve spent a lot of time meticulously cleaning the bed, and ... In forum Others (Archive)	7 years temu
	I’ve spent a lot of time meticulously cleaning the bed, and ... In forum Others (Archive)	7 years temu
	Thanks for all the replies! I will see if it shows up in the... In forum Others (Archive)	7 years temu
	MK2 MMU how to enable single material mode??? In forum Others (Archive)	7 years temu
	MMU Post Processor decreasing temps after first layer In forum Others (Archive)	7 years temu
	Just a thought here, it appears as if a few people have had ... In forum Others (Archive)	7 years temu

Statystyki Forum

565 Fora

63.9 K Tematy

447.8 K Posty

20 Online

69.6 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte