Prusa3D Forum

Notifications

Clear all

hillinator

Skupina: Registrovaný

Přidal se: 2017/12/07

Active Member

	howdy folks. I had this issue last night with a new hotend f... In forum Hardware, firmware and software help	před 5 months
	"avoid crossing perimeters" Jams up Slic3r while s... In forum Others (Archive)	před 7 years
	I assumed the word "meticulously" implied I had tried cleani... In forum Others (Archive)	před 7 years
	found it!! if you load the generic MK2 profiles in slic3r yo... In forum Others (Archive)	před 7 years
	I’ve spent a lot of time meticulously cleaning the bed, and ... In forum Others (Archive)	před 7 years
	I’ve spent a lot of time meticulously cleaning the bed, and ... In forum Others (Archive)	před 7 years
	Thanks for all the replies! I will see if it shows up in the... In forum Others (Archive)	před 7 years
	MK2 MMU how to enable single material mode??? In forum Others (Archive)	před 7 years
	MMU Post Processor decreasing temps after first layer In forum Others (Archive)	před 7 years
	Just a thought here, it appears as if a few people have had ... In forum Others (Archive)	před 7 years

Fórum Statistiky

565 Fóra

64.1 K Témata

449.2 K Příspěvky

20 Online

70.2 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed