Prusa3D Forum

Notifications

Clear all

hillinator

Groupe: Enregistré

A(ont) rejoint: 2017/12/07

Active Member

	howdy folks. I had this issue last night with a new hotend f... Dans le forum Hardware, firmware and software help	il y a 5 months
	"avoid crossing perimeters" Jams up Slic3r while s... Dans le forum Others (Archive)	il y a 7 years
	I assumed the word "meticulously" implied I had tried cleani... Dans le forum Others (Archive)	il y a 7 years
	found it!! if you load the generic MK2 profiles in slic3r yo... Dans le forum Others (Archive)	il y a 7 years
	I’ve spent a lot of time meticulously cleaning the bed, and ... Dans le forum Others (Archive)	il y a 7 years
	I’ve spent a lot of time meticulously cleaning the bed, and ... Dans le forum Others (Archive)	il y a 7 years
	Thanks for all the replies! I will see if it shows up in the... Dans le forum Others (Archive)	il y a 7 years
	MK2 MMU how to enable single material mode??? Dans le forum Others (Archive)	il y a 7 years
	MMU Post Processor decreasing temps after first layer Dans le forum Others (Archive)	il y a 7 years
	Just a thought here, it appears as if a few people have had ... Dans le forum Others (Archive)	il y a 7 years

Statistiques du forum

565 Forums

64.1 K Sujets

449.1 K Messages

17 En-ligne

70.2 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé