Prusa3D Forum

Notifications

Clear all

Helmi

Skupina: Registrovaný

Přidal se: 2016/09/02

Active Member

	Y calibration fails but printing looks fine In forum Assembly and first prints troubleshooting	před 12 months
	MK2.5S with MMUS2 failing after latest Firmware update? In forum Hardware, firmware and software help	před 5 years
	MMU2 first impressions (Mk 2.5) In forum General discussion, announcements and releases	před 6 years
	Black & white results in grey In forum Others (Archive)	před 7 years
	Bed connector going hot In forum Others (Archive)	před 8 years
	@jeroen.b no, roomt temperature is quite normal (~21°C) @PJ... In forum Others (Archive)	před 8 years
	@Vojtech we finally got it fixed. The problem is the exact ... In forum Others (Archive)	před 8 years
	hmm I just noticed in another Print that it's not only the f... In forum Others (Archive)	před 8 years
	Thermal Runaway In forum Others (Archive)	před 8 years
	I tried the latest version. It's getting better but we're ... In forum Others (Archive)	před 8 years
	Hi Vojtech, thanks for beeing transparent and open on this.... In forum Others (Archive)	před 8 years
	Thanks for replying so quickly. By binary I was talking abo... In forum Others (Archive)	před 8 years
	@Jo @Vojtech It would be good to see a compiled version of t... In forum Others (Archive)	před 8 years

Fórum Statistiky

559 Fóra

62.8 K Témata

442.2 K Příspěvky

18 Online

67.3 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed