Prusa3D Forum

Notifications

Clear all

Helmi

Grupa: Zarejestrowany

Dołączył: 2016/09/02

Active Member

	Y calibration fails but printing looks fine In forum Assembly and first prints troubleshooting	1 year temu
	MK2.5S with MMUS2 failing after latest Firmware update? In forum Hardware, firmware and software help	5 years temu
	MMU2 first impressions (Mk 2.5) In forum General discussion, announcements and releases	6 years temu
	Black & white results in grey In forum Others (Archive)	7 years temu
	Bed connector going hot In forum Others (Archive)	8 years temu
	@jeroen.b no, roomt temperature is quite normal (~21°C) @PJ... In forum Others (Archive)	8 years temu
	@Vojtech we finally got it fixed. The problem is the exact ... In forum Others (Archive)	8 years temu
	hmm I just noticed in another Print that it's not only the f... In forum Others (Archive)	8 years temu
	Thermal Runaway In forum Others (Archive)	8 years temu
	I tried the latest version. It's getting better but we're ... In forum Others (Archive)	8 years temu
	Hi Vojtech, thanks for beeing transparent and open on this.... In forum Others (Archive)	8 years temu
	Thanks for replying so quickly. By binary I was talking abo... In forum Others (Archive)	8 years temu
	@Jo @Vojtech It would be good to see a compiled version of t... In forum Others (Archive)	8 years temu

Statystyki Forum

559 Fora

63.1 K Tematy

443.9 K Posty

18 Online

68.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte