Prusa3D Forum

Notifications

Clear all

harryg

Groupe: Enregistré

A(ont) rejoint: 2017/04/07

Active Member

	Thanks a lot (and there is absolutely nothing wrong with the... Dans le forum Improvements (Archive)	il y a 7 years
	Someone posted a good illustration on what causes the belt t... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	You should probably tell Prusa about their poor design, sinc... Dans le forum Improvements (Archive)	il y a 7 years
	I have modified the x-carriage on my MK2S to allow belt adj... Dans le forum Prusa i3 kit (Archive)	il y a 7 years
	I modified the original STL to mimic the new design and I al... Dans le forum Improvements (Archive)	il y a 7 years
	Anyone have recommendations for rods with the igus RJ4JP bea... Dans le forum Hardware, firmware and software help	il y a 7 years
	[/quote] Thanks. I have a feeling it's due to the x-axis. Y... Dans le forum Hardware, firmware and software help	il y a 7 years
	Just fitted some RJ4JP-01-08 igus bearings to my mk2s and no... Dans le forum Hardware, firmware and software help	il y a 7 years
	I'll chime in, ordered black/orange kit on April 6 just rece... Dans le forum General discussion, announcements and releases	il y a 7 years

Statistiques du forum

559 Forums

63.1 K Sujets

443.9 K Messages

20 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé