Prusa3D Forum

Benachrichtigungen

Alles löschen

harryg

Gruppe: Registriert

Beigetreten: 2017/04/07

Active Member

	Thanks a lot (and there is absolutely nothing wrong with the... Im Forum Improvements (Archive)	Vor 7 years
	Someone posted a good illustration on what causes the belt t... Im Forum Prusa i3 kit (Archive)	Vor 7 years
	You should probably tell Prusa about their poor design, sinc... Im Forum Improvements (Archive)	Vor 7 years
	I have modified the x-carriage on my MK2S to allow belt adj... Im Forum Prusa i3 kit (Archive)	Vor 7 years
	I modified the original STL to mimic the new design and I al... Im Forum Improvements (Archive)	Vor 7 years
	Anyone have recommendations for rods with the igus RJ4JP bea... Im Forum Hardware, firmware and software help	Vor 8 years
	[/quote] Thanks. I have a feeling it's due to the x-axis. Y... Im Forum Hardware, firmware and software help	Vor 8 years
	Just fitted some RJ4JP-01-08 igus bearings to my mk2s and no... Im Forum Hardware, firmware and software help	Vor 8 years
	I'll chime in, ordered black/orange kit on April 6 just rece... Im Forum General discussion, announcements and releases	Vor 8 years

Forums-Statistiken

565 Foren

64.5 K Themen

452 K Beiträge

26 Online

71.2 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen