Notifications
Clear all
HappyKatz
Group: Registered
Joined: 2021/09/27
Estimable Member
4
| That's interesting - it did not occur to me to check the bel... | 4 years ago | |
| Waves in first layer | 4 years ago | |
| My experience tallies with that of @baklin. The MMU2+ is a w... | 4 years ago | |
| Thank you! I am glad to hear that. As a bonus question - I h... | 4 years ago | |
| Filament spool holders for the MINI+ | 4 years ago | |
| I think there is some validity to the scatter effect impacti... | 4 years ago | |
| I found this post when I discovered that - after fully execu... | 4 years ago | |
| Note to self: a clean build plate is a successful build plat... | 4 years ago | |
| Thank you Dan and JW - finally managed to get it off! @jwva... | 4 years ago | |
| Filament covering extruder - help! | 4 years ago | |
| That was exactly what I was looking for 🙂 I will try out r... | 4 years ago | |
| Pitting on 3D printed surface | 4 years ago |
Page 6 / 6
Prev