Notifications
Clear all
Hans van der Pol
Grupa: Zarejestrowany
Dołączył: 2025/04/10
Active Member
1
|
Thanks, There was no damage visible on the flat-cable, but w... In forum Hardware, firmware and software help |
5 months temu | |
|
I found out that the knocking sound of the stepper motor was... In forum Hardware, firmware and software help |
5 months temu | |
|
Thanks for all the help. I ruled out this interference the r... In forum Hardware, firmware and software help |
5 months temu | |
|
Yes, First I tried a factory reset and that changed nothing ... In forum Hardware, firmware and software help |
5 months temu | |
|
No, there are no noticeable obstructions. I put the printer ... In forum Hardware, firmware and software help |
5 months temu | |
|
Hiccup every 3 rotations on x-as and y-as In forum Hardware, firmware and software help |
5 months temu |