Prusa3D Forum

Notifications

Clear all

Hans van der Pol

Skupina: Registrovaný

Přidal se: 2025/04/10

Active Member

	Thanks, There was no damage visible on the flat-cable, but w... In forum Hardware, firmware and software help	před 1 year
	I found out that the knocking sound of the stepper motor was... In forum Hardware, firmware and software help	před 1 year
	Thanks for all the help. I ruled out this interference the r... In forum Hardware, firmware and software help	před 1 year
	Yes, First I tried a factory reset and that changed nothing ... In forum Hardware, firmware and software help	před 1 year
	No, there are no noticeable obstructions. I put the printer ... In forum Hardware, firmware and software help	před 1 year
	Hiccup every 3 rotations on x-as and y-as In forum Hardware, firmware and software help	před 1 year

Fórum Statistiky

598 Fóra

71.6 K Témata

502.8 K Příspěvky

12 Online

82.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed