Notifications
Clear all
Hans van der Pol
Groupe: Enregistré
A(ont) rejoint: 2025/04/10
Active Member
1
|
Thanks, There was no damage visible on the flat-cable, but w... Dans le forum Hardware, firmware and software help |
il y a 4 months | |
|
I found out that the knocking sound of the stepper motor was... Dans le forum Hardware, firmware and software help |
il y a 4 months | |
|
Thanks for all the help. I ruled out this interference the r... Dans le forum Hardware, firmware and software help |
il y a 5 months | |
|
Yes, First I tried a factory reset and that changed nothing ... Dans le forum Hardware, firmware and software help |
il y a 5 months | |
|
No, there are no noticeable obstructions. I put the printer ... Dans le forum Hardware, firmware and software help |
il y a 5 months | |
|
Hiccup every 3 rotations on x-as and y-as Dans le forum Hardware, firmware and software help |
il y a 5 months |