Prusa3D Forum

Notifiche

Cancella tutti

Hans van der Pol

Gruppo: Registrato

Registrato: 2025/04/10

Active Member

	Thanks, There was no damage visible on the flat-cable, but w... Nel forum Hardware, firmware and software help	4 months fa
	I found out that the knocking sound of the stepper motor was... Nel forum Hardware, firmware and software help	5 months fa
	Thanks for all the help. I ruled out this interference the r... Nel forum Hardware, firmware and software help	5 months fa
	Yes, First I tried a factory reset and that changed nothing ... Nel forum Hardware, firmware and software help	5 months fa
	No, there are no noticeable obstructions. I put the printer ... Nel forum Hardware, firmware and software help	5 months fa
	Hiccup every 3 rotations on x-as and y-as Nel forum Hardware, firmware and software help	5 months fa

Statistiche Forum

585 Forum

68.1 K Discussioni

477.2 K Post

11 Online

75.8 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso