Prusa3D Forum

Notifications

Clear all

Hans van der Pol

Group: Registered

Joined: 2025/04/10

Active Member

	Thanks, There was no damage visible on the flat-cable, but w... In forum Hardware, firmware and software help	4 months ago
	I found out that the knocking sound of the stepper motor was... In forum Hardware, firmware and software help	4 months ago
	Thanks for all the help. I ruled out this interference the r... In forum Hardware, firmware and software help	5 months ago
	Yes, First I tried a factory reset and that changed nothing ... In forum Hardware, firmware and software help	5 months ago
	No, there are no noticeable obstructions. I put the printer ... In forum Hardware, firmware and software help	5 months ago
	Hiccup every 3 rotations on x-as and y-as In forum Hardware, firmware and software help	5 months ago

Forum Statistics

585 Forums

68.1 K Topics

477 K Posts

10 Online

75.8 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed